I am running some mechanical parts ( 4th axis ) and ran a .250 flat roughing pass then wanted to do a Horizontal Re-Rouging with a .125 flat. No matter what I did to the settings I kept getting the massage about (invalid arguments) ??? I could not figure it out. I was using a region to contain the cutter and trying to cut the entire bottom cut. Could this have something to do with it?
Correct me if I am wrong but this function is for re-roughing what is left by the previous mop right? What could I be doing wrong? OR is there maybe a bug in this algorithm?
Any help on this would be great.
Bill
Horizontal Re-Rouging??
-
- Posts: 15
- Joined: Wed Aug 01, 2007 4:15 pm
- Location: Riverside CA USA