I am using "inch" units for doing my machining. My part is 5 inches in diameter and 2 inches in depth.
When I use the "Compare Part/Stock Models" on my last machining operation and use a "Tolerance Band" of "0.5". I get a mostly a blue part which means that it is "more than 0.5" as per the legend.
So my question is:
What are the units used in the "Compare Part/Stock" dialog box??...it obviously is NOT inches!
Thanks!
[Edited by biomed_eng_2000 on 25-Jan-04 19:43]
Units for "Compare Part/Stock Models"??
-
biomed_eng_2000
- Posts: 22
- Joined: Wed Aug 01, 2007 4:15 pm
- Location: Irvine, CA, USA, NA, Earth
-
MecSoft Support
- Posts: 2405
- Joined: Wed Aug 01, 2007 4:15 pm
- Location: Irvine, CA, USA
- Contact:
Units for \"Compare Part/Stock Models\"??
The units for compare part/stock is whatever the current units of the part is in. Sometimes due to the geometry of the part the algorithm might give erroneous results. If you are having a problem with a specific part please send it to [email protected] for us to check it out.
MecSoft Support
MecSoft Support