SP 2 Engraving Bugs.

Brant · Post by **Brant** » Sun Jan 25, 2004 6:03 am

You cannot set the "To Condition" for engraving, if you do when you save then edit your settings both "On Condition" and "To Condition" are selected.
Also on the"Entry/Exit" Tab any changes are not save and are reset to default when saved. The "Cut Transfer" "Skim" setting can be saved but is ignored and the "Clearance Plane" is always used.

Regards Mark.

Post by **MecSoft Support** » Wed Jan 28, 2004 4:00 pm

This has been fixed and will show up in our Service Pack 3. Should be out by first week of Feb.