You cannot set the "To Condition" for engraving, if you do when you save then edit your settings both "On Condition" and "To Condition" are selected.
Also on the"Entry/Exit" Tab any changes are not save and are reset to default when saved. The "Cut Transfer" "Skim" setting can be saved but is ignored and the "Clearance Plane" is always used.
Regards Mark.
SP 2 Engraving Bugs.
-
- Posts: 2405
- Joined: Wed Aug 01, 2007 4:15 pm
- Location: Irvine, CA, USA
- Contact:
SP 2 Engraving Bugs.
This has been fixed and will show up in our Service Pack 3. Should be out by first week of Feb.