Changing start point
Posted: Sun Dec 07, 2003 2:05 pm
Hello, All.
I am trying to 2.5 profile mill 2 identical parts.
One is a copy that is rotated 180 deg around from the other.
I can change the start point on one easily, but when I try
to change it on the other part, the dot just goes back where it was before.
Any Ideas?
Thanks, John
I am trying to 2.5 profile mill 2 identical parts.
One is a copy that is rotated 180 deg around from the other.
I can change the start point on one easily, but when I try
to change it on the other part, the dot just goes back where it was before.
Any Ideas?
Thanks, John