change chamfering or profile start position
Posted: Wed Apr 08, 2020 4:06 pm
hello,
what is the easiest way to define a start position or entrance point for a 2d tool path on a part that was imported? I'm guessing it easy to control a start position if i made the model in viusalCAM but since I'm using an imported model I don't see that option. Ideally the profile would start midpoint on a line segment I select.
thanks
Erik
what is the easiest way to define a start position or entrance point for a 2d tool path on a part that was imported? I'm guessing it easy to control a start position if i made the model in viusalCAM but since I'm using an imported model I don't see that option. Ideally the profile would start midpoint on a line segment I select.
thanks
Erik