toolpath is too long and complicated/UNITE
Posted: Fri Dec 27, 2019 7:29 am
Hello everyone. I am new to forum and new too also Visual CAD/CAM.
Does anyone can help me about two points?
I am using Visual CAD/CAM visual Mill 2019 edition.
1.
After I generate, I think the generated toolpath is too long and complicated. It goes to one corner and comes back again pointless (without any logic).
I mean there is too much idle movement of tool without drilling.
How can I optimize toolpath movements?
2.
How can I unite (mesh menu) different solids?
Does unite command work only for 2 different solids?
I want to unite like 80 different solids. But the command does not allow this. Is there a way to unite more than 2 solids?
Thanks in advance for your invaluable support.
Does anyone can help me about two points?
I am using Visual CAD/CAM visual Mill 2019 edition.
1.
After I generate, I think the generated toolpath is too long and complicated. It goes to one corner and comes back again pointless (without any logic).
I mean there is too much idle movement of tool without drilling.
How can I optimize toolpath movements?
2.
How can I unite (mesh menu) different solids?
Does unite command work only for 2 different solids?
I want to unite like 80 different solids. But the command does not allow this. Is there a way to unite more than 2 solids?
Thanks in advance for your invaluable support.