Rhino G code for arc/circular engrave is not working
Posted: Tue Aug 07, 2018 1:11 pm
I have a Shopbot and the g-code for a paddle I'm trying to cut out is not translating to my post processor for Shopbot. Any thoughts? G-code that it produces is below:
JZ, 0.0000
J2, 0.0000 , 0.0000
M5,,,,0,0
SO,1,1
'Engraving_Paddle
MS,2.92,2.92
M3,11.3602,4.1942,0.2500
M3,11.3602,4.1942,-0.0981
M3,11.3549,3.1942,-0.0981
M3,7.2090,3.2165,-0.0981
M3,11.3602,4.1942,0.2500
JZ, 0.0000
SO,1,0
J2, 0.0000 , 0.0000
M5,,,,0,0
JZ, 0.0000
J2, 0.0000 , 0.0000
M5,,,,0,0
SO,1,1
'Engraving_Paddle
MS,2.92,2.92
M3,11.3602,4.1942,0.2500
M3,11.3602,4.1942,-0.0981
M3,11.3549,3.1942,-0.0981
M3,7.2090,3.2165,-0.0981
M3,11.3602,4.1942,0.2500
JZ, 0.0000
SO,1,0
J2, 0.0000 , 0.0000
M5,,,,0,0