Re-machining
-
- Posts: 2
- Joined: Tue Oct 18, 2016 1:42 pm
Re-machining
I updated to Rhinocam 2018 and Rhino 6 this morning and I can't get the re-machining operation to work on a profile. I was able to generate the path no problem with the same geometry in Rhinocam 2016 and Rhino 5. Any solutions or trouble shooting ideas?
-
- Posts: 2405
- Joined: Wed Aug 01, 2007 4:15 pm
- Location: Irvine, CA, USA
- Contact:
Re: Re-machining
If you could upload the file or email it to us at [email protected] we can take a look at it.