Entry perpendicular to circle
Posted: Mon Jan 11, 2016 1:25 pm
Rhino 4.0 SR9
Rhino CAM 3.0.0.48
Everything in millimeters.
Draw a circle (center at 0,0, diameter 100)
Do 2-axis engraving, cut 1 mm deep in one pass.
Set 3D entry, linear (length 3.175, Angle 20 is what RhinoCAM gave me)
The problem is that the entry path is perpendicular to the circle!
Here's a picture
Rhino CAM 3.0.0.48
Everything in millimeters.
Draw a circle (center at 0,0, diameter 100)
Do 2-axis engraving, cut 1 mm deep in one pass.
Set 3D entry, linear (length 3.175, Angle 20 is what RhinoCAM gave me)
The problem is that the entry path is perpendicular to the circle!
Here's a picture