Having trouble with plunge roughing (had to revert to BobCad to get it done) Antway, the tool path will not cover the stock I need to remove. Visualcam will not take the first passes to depth and it will end up with a full cut condition and the tool can not survive. I have noticed that I can make the stock smaller and the tool path looks better but that is not what I am working with on this job. Let me know if I am doing something wrong.
I would think that you would want to add a depth control to your plunge rough cycle also. In this case we only want to go a little beyond centerline but I dont seem to have a way to control it like I do some other 3d operations.
Plunge Roughing
-
- Posts: 24
- Joined: Thu Dec 03, 2015 2:13 pm
- Location: Michigan
- Contact:
Plunge Roughing
- Attachments
-
- Plunge Rough.jpg (576.47 KiB) Viewed 11059 times
-
- Posts: 24
- Joined: Thu Dec 03, 2015 2:13 pm
- Location: Michigan
- Contact:
Re: Plunge Roughing
Here is another view. I tried to upload the visualcam file but its too large. Stock is 15.2 OD
- Attachments
-
- view2.jpg (308.46 KiB) Viewed 11054 times
-
- Posts: 2405
- Joined: Wed Aug 01, 2007 4:15 pm
- Location: Irvine, CA, USA
- Contact:
Re: Plunge Roughing
We have added a depth control, similar to horizontal roughing, enhancement to the system. Thanks.
-
- Posts: 24
- Joined: Thu Dec 03, 2015 2:13 pm
- Location: Michigan
- Contact:
Re: Plunge Roughing
How do I get the update?
Also why was it not drilling to the model?
Also why was it not drilling to the model?