Pathpilot post stopping before end of program
Posted: Mon Nov 30, 2015 2:41 pm
I have updated Visualmill to 2015 in order to have a Pathpilot post for my Tormach Mill
The program stops three lines before the end of the file.
M6 T0 (stops and asks for a tool change to T0 then press cycle start.)
M5 M9
M30
T0 is set up to have a 0 offset in the tool table (recommended by Tormach)
1. What is the reason for this code to be there.
2. Can it be removed so that the coolent and spindle can be switched off and the code returns to the start without my input.
Many thanks.
John.
The program stops three lines before the end of the file.
M6 T0 (stops and asks for a tool change to T0 then press cycle start.)
M5 M9
M30
T0 is set up to have a 0 offset in the tool table (recommended by Tormach)
1. What is the reason for this code to be there.
2. Can it be removed so that the coolent and spindle can be switched off and the code returns to the start without my input.
Many thanks.
John.