selecting holes
Posted: Fri Jan 27, 2012 4:38 pm
If I understand correctly I can only select sketches of holes.
If this is so this makes Visual Mill for Solid Works entirely useless.
In stand alone Visual Mill I pick the holes with a selection box and then sort them.
I regularly design parts that have tens to hundreds of holes and this is done using the hole wizard
so the thread information is picked up and used when I fill the holes with fasteners from SW toolbox
and then these fasteners go on to my parts lists.
these holes are mostly holes that have been patterned (circular and rectangular) .
jb
If this is so this makes Visual Mill for Solid Works entirely useless.
In stand alone Visual Mill I pick the holes with a selection box and then sort them.
I regularly design parts that have tens to hundreds of holes and this is done using the hole wizard
so the thread information is picked up and used when I fill the holes with fasteners from SW toolbox
and then these fasteners go on to my parts lists.
these holes are mostly holes that have been patterned (circular and rectangular) .
jb