Start point for 2.5d profiling
Posted: Fri Nov 11, 2011 8:07 am
Anyone here know how to select the start or entry point for 2.5d profiling?
e.g. I have a 3D part that I'd like to profile with 2.5d profiling. I have a 2d sketch that's made using convert entities from the profile of the part. I use this so that I can use the "select curves as features" because I'm using configurations to control custom parts. If I select the face as the profile, I'd have to re-select it for every regen.
VM then pics a start point for me which in this case is o.k. but not ideal. Is there any way to pick the start point?
e.g. I have a 3D part that I'd like to profile with 2.5d profiling. I have a 2d sketch that's made using convert entities from the profile of the part. I use this so that I can use the "select curves as features" because I'm using configurations to control custom parts. If I select the face as the profile, I'd have to re-select it for every regen.
VM then pics a start point for me which in this case is o.k. but not ideal. Is there any way to pick the start point?