I'm trying to setup a post for a WireEDM machine.
I've got it almost completely done, but I'm struggling to get a few codes on the correct place.
I need to insert specific M codes at the beggining and end of each profile
to be cut. These are M codes for cutting and inserting the wire.
In attach there's an example of what I need.
Any help is much appreciated.
Thanks.
Post Processor for Wire EDM
Post Processor for Wire EDM
- Attachments
-
- WIRE_EDM.ZIP
- (394.38 KiB) Downloaded 1182 times
Best regards
JVidal
JVidal
Post Processor for Wire EDM (Charmilles)
this one for the Charmilles
works very good
I used Engraving
use with cutter comp
and post as iso file
megclay
works very good
I used Engraving
use with cutter comp
and post as iso file
megclay
- Attachments
-
- WIRE EDM Charmilles Robofill 310.zip
- (2.14 KiB) Downloaded 1276 times