I'm working on a mould with left and right mirror image cavities, to speed up calculation time I used only one cavity. When all the MOPs looked correct I then tried to use the tool path editor to create mirror copies of the tool paths. The problem is the original tool paths are erased even if you select Create Copy.
Mark.
Can't get mirror to make copy.
-
MecSoft Support
- Posts: 2405
- Joined: Wed Aug 01, 2007 4:15 pm
- Location: Irvine, CA, USA
- Contact:
Can\'t get mirror to make copy.
Hi Mark,
It is a bug. Dev already knows about this and has fixed it. The fix for this will show up in the next service pack SP6.
If you need a pre-release send us email at [email protected]
[Edited by MecSoft Support on 17-May-04 14:12]
It is a bug. Dev already knows about this and has fixed it. The fix for this will show up in the next service pack SP6.
If you need a pre-release send us email at [email protected]
[Edited by MecSoft Support on 17-May-04 14:12]