I like the new feeds/speeds dialog, however, when making multiple passes during a 2.5d profile, the plunge feed (Pf) is only used on the initial plunge (first pass) and the Transfer feed (Tf) is only used when the last pass of the profile is finished (End of the MOP)... The middle passes use the Engage Feedrate (Ef) for all plunges and transfers between each z level.. Is there a way to force VM5 to use the (Pf) and (Tf) between each pass?
Thanks
Denis
[Edited by Denis on 12-Dec-03 16:34]
Feed rates question...
-
- Posts: 2405
- Joined: Wed Aug 01, 2007 4:15 pm
- Location: Irvine, CA, USA
- Contact:
Feed rates question...
We will look into this for the upcoming service packs