I'm finally using my 4th axis ability and have it "running" on my machine.
However. When using the gCode, all my axis movements runs EXTREMELY SLOW!!!! It's got a speed setting of G06, if I change the code to G00 it of course runs faster. What am I missing in my 4th axis setup?
Thanks.
4th axis gcode
Re: 4th axis gcode
check the programming manual for your machine.
What is the 4th axis feed rate supposed to be calculated in?
Does this compare to the outputted G code?
If it does then you must have a parameter in the machine control wrong or something.
What is the 4th axis feed rate supposed to be calculated in?
Does this compare to the outputted G code?
If it does then you must have a parameter in the machine control wrong or something.
integratedmechanical.ca
Re: 4th axis gcode
Not sure how to figure out what my 4th axis feed rate would be calculated in. No manual.
I'm sure it's a parameter issue, just no idea what parameter to even modify.
I'm sure it's a parameter issue, just no idea what parameter to even modify.