In order to do some 3D engraving, I'd like to project up to 20 lines on to a 3D surface. The location of these lines will be controlled by a spreadsheet (a linear pattern with varying distances between the lines).
First is my Solidworks problem:
Problem is that the project curve feature will only work with one line. i.e. if I put 2 or more lines onto a single sketch, it poops out and no workey. I'd have to make an independent sketch and then feature for each line I wish to project and I just gotta think that there must be an easier way.
The VisualMILL problem is that when I use the project curve feature, I can't select the projected curve unless I make a new 3D sketch and convert the entity. Am I missing something here?
When I convert the entity into a new 3D sketch, I get the exact machining results I'm looking for.
Is there some other way I could do this in VisualMill without making a curved feature in Solidworks? Perhaps something like a 3D offset pocket or something? Basically I'm looking for ways to streamline this process. Being able to select the curve entity as a region would be best.
Any Ideas?
Help with 3D engraving
-
- Posts: 13
- Joined: Sun Feb 13, 2011 12:51 pm
- Contact:
Help with 3D engraving
- Attachments
-
- Screen shot 2011-10-20 at 9.44.28 AM.png (291.72 KiB) Viewed 9761 times
-
- Posts: 2405
- Joined: Wed Aug 01, 2007 4:15 pm
- Location: Irvine, CA, USA
- Contact:
Re: Help with 3D engraving
Use Curve Machining & select the 2d Sketch lines as your machining regions.Is there some other way I could do this in VisualMill without making a curved feature in Solidworks? Perhaps something like a 3D offset pocket or something? Basically I'm looking for ways to streamline this process. Being able to select the curve entity as a region would be best.
This method can be found under 3 axis toolpath methods & projects the toolpath to the 3d surface.
-
- Posts: 13
- Joined: Sun Feb 13, 2011 12:51 pm
- Contact:
Re: Help with 3D engraving
Thanks, I tried that but it didn't do what I wanted.
I did figure it out though - I used some features in solidworks to make 3D curves that I could select with 2.5d engraving and VM follows the curves perfectly!!
I did figure it out though - I used some features in solidworks to make 3D curves that I could select with 2.5d engraving and VM follows the curves perfectly!!