I need to output one of two commands, weather I'm programming a rough or finish strategy. On the headline I must have BRISK for roughing strategies or SOFT for finishing strategies.
These are special commands for the Siemens802D controller.
Is there any variable I may use or any place to write the command to output within VisualMILL without having to manually edit the post each time?
PS: I know I may have two different posts, but I was hoping that there was a workaround to avoid this.
Thanks!
Special Command
Special Command
Best regards
JVidal
JVidal
I don't believe this can be done with any top level function.
My request here http://www.mecsoft.com/phpbb/viewtopic.php?t=1848 would work, but you would still have to input by hand.
There are a lot of simple and intuitive enhancement requests that we have been waiting a long time for.
My request here http://www.mecsoft.com/phpbb/viewtopic.php?t=1848 would work, but you would still have to input by hand.
There are a lot of simple and intuitive enhancement requests that we have been waiting a long time for.
integratedmechanical.ca