Enhancement request - mass selection of flat area features
Enhancement request - mass selection of flat area features
It's pretty easy to select multiple curves in one go in VM4SW, but selecting a flat area feature is done on a one-at-a-time basis going back and forth between dialogs, rather than being able to select a number of faces at once.
-
- Posts: 2405
- Joined: Wed Aug 01, 2007 4:15 pm
- Location: Irvine, CA, USA
- Contact:
-
- Posts: 34
- Joined: Fri Jan 22, 2010 10:08 am
While we're at it, can we get "Select Chain" worki
While we're at it, can we get "Select Chain" working again? It's a real bear to sit there and click a hundred little segments only to have them all go poof when the "Open loops found" window comes up because you missed one.
Andy Baker
Brooklyn, NY
Brooklyn, NY