Hi - a while back I posted asking how this was done. http://www.mecsoft.com/phpbb/viewtopic. ... ight=#3796
All has worked fine until today. Using "Adjust closed curve seam" I've moved several toolpath start/end points on my design but on one curve the toolpath starts/ends in exactly the same place regardless of where I move the seam to. Any ideas why its failing on one curve only? TIA
problem moving 2.5D toolpath entry exit point on region
-
- Posts: 2405
- Joined: Wed Aug 01, 2007 4:15 pm
- Location: Irvine, CA, USA
- Contact:
Whistler,
Send us the file to [email protected] and we can take a look at it.
Send us the file to [email protected] and we can take a look at it.