Hello all
I have a customer machining in Rhinocam pro with 5 axis indexed.
In the link bellow the customer can't make rhinocam rotate the 4 and 5 axis , this is done in the axis B and C but
seems that in the output is not done.
http://www.paraglobal-3d.com/download/p ... upport.rar
What are we missing here?
Regards
Sergio Silva
5 Axis indexed
-
- Posts: 16
- Joined: Wed Aug 01, 2007 4:15 pm
- Location: Portugal
- Contact:
-
- Posts: 2405
- Joined: Wed Aug 01, 2007 4:15 pm
- Location: Irvine, CA, USA
- Contact:
Hello Sergio,
The post processors for RhinoCAM 1.0 are setup for 2 1/2, 3 axis 4 axis. You would need obtain a custom post for 5 axis.
Please contact [email protected] for information on 5 axis posts.
The post processors for RhinoCAM 1.0 are setup for 2 1/2, 3 axis 4 axis. You would need obtain a custom post for 5 axis.
Please contact [email protected] for information on 5 axis posts.