Transforming Toolpath
-
Initial Image
- Posts: 54
- Joined: Wed Aug 01, 2007 4:15 pm
- Location: Texas
Transforming Toolpath
I would like to be able to click on the entire Mahining Op and transform all the toolpath into my desired grid pattern all at once versus doing each one individually. Is it possible to do this?
-
MecSoft Support
- Posts: 2405
- Joined: Wed Aug 01, 2007 4:15 pm
- Location: Irvine, CA, USA
- Contact:
Transforming Toolpath
Hi,
Currently in V5.0 this is not possible but this is an enhancement request that many people have requested and will be in our next release.
Currently in V5.0 this is not possible but this is an enhancement request that many people have requested and will be in our next release.