Hi, I've encountered another problem:
When creating a toolpath "plateau machining" my (German) VM5
the software makes unidirectional toolpathes instead of bidirectional !?
Any ideas ?
FastLars
Toolpath ?!
-
- Posts: 2405
- Joined: Wed Aug 01, 2007 4:15 pm
- Location: Irvine, CA, USA
- Contact:
Toolpath ?!
The cut direction parameters for Linear Cuts under Plateau Machining was not being transfered correctly. We have fixed this problem and will show up in the next service pack (SP5). This will be released in this week (Week of May 3rd). In case you need to get this sooner, send email to [email protected]