I have been having a lot of problems with profiling in RhinoCam with tools that take odd paths and gouge the part. Here is one example:
I have some round holes with flat sides to cut for toggle switches that have flats on the sides, basically curved on the top, curved on the bottom, with straight lines joining the sides. A "D" shaped hole would give the same problem.
What the tool should do is enter inside the hole and just follow the profile all the way around the profile then exit. What it is doing is making four separate entries and exits, one for each segment. The entries and exits for the flat sides gouge the curved parts, and the entries and exits for the curved parts gouge the flat parts. Making the entries and exits zero length still gives me four separate cuts and overshoots each end and is still gouging.
I have figured out that the program is cutting out the material in the corners instead of leaving the radius due to the round tool there. I did some experimenting with square holes and they cut just fine. I tried corner rounding and it did not fix anything. it rounded the square holes more, but did nothing to my round/flat holes. Any suggestions?
Why in the world is the program not smart enough to just not cut into the part where it should not cut? Obviously, if the model has material in an area and it knows that it is cutting that material out it should know that there is a problem.
Big problems with profiling in RhinoCam
I tried to put on an attachment, but it would not let me. For some reason it is now.
- Attachments
-
- sample hole.3dm
- (55.63 KiB) Downloaded 829 times
-
- sample hole.3dm
- (55.63 KiB) Downloaded 839 times
-
- Posts: 2405
- Joined: Wed Aug 01, 2007 4:15 pm
- Location: Irvine, CA, USA
- Contact: