Hi!
Can VM5 load the tool library automatically as VM4 did?
Copying the visualmill.ini from VM4 to VM5 wasn't successfully... grr.
Best regards
FastLars
Tools load at startup ?!
-
MecSoft Support
- Posts: 2405
- Joined: Wed Aug 01, 2007 4:15 pm
- Location: Irvine, CA, USA
- Contact:
Tools load at startup ?!
Hi FastLars,
In VM 5.0 we have made automatic loading of tool libraries even more convenient. Just load the tool library manualy once when you are in VM5.0. The next time you launch VM 5.0 the same tool library file will be loaded automatically. VM "remembers" this and loads it automatically. You cannot use this scheme in conjunction with the .ini file however.
In VM 5.0 we have made automatic loading of tool libraries even more convenient. Just load the tool library manualy once when you are in VM5.0. The next time you launch VM 5.0 the same tool library file will be loaded automatically. VM "remembers" this and loads it automatically. You cannot use this scheme in conjunction with the .ini file however.
Tools load at startup ?!
Thx support.
The problem was, that I didn't had enough rights on the installed folder ?! However, changing the rights did the job.
The problem was, that I didn't had enough rights on the installed folder ?! However, changing the rights did the job.