Freemill Functionality ?

cvarney · Post by **cvarney** » Thu Apr 01, 2004 1:07 pm

I'm a user of VM5.0 but wanted to play with Freemill. It installed OK and loads a simple model but the user interface seems to me missing. The only menus available at top of screen are "View" and "About"

Am I overlooking the obvious ? I know there is no support offered for this product and am hoping that my post here isn't inappropriate.

Thanks

Chauncey

Post by **MecSoft Support** » Thu Apr 01, 2004 5:37 pm

Make sure the Wizard Bar under the View menu item is checked.

This will bring up a dockable dialog bar on the side where you can enter parameters to program parts.