I'm a user of VM5.0 but wanted to play with Freemill. It installed OK and loads a simple model but the user interface seems to me missing. The only menus available at top of screen are "View" and "About"
Am I overlooking the obvious ? I know there is no support offered for this product and am hoping that my post here isn't inappropriate.
Thanks
Chauncey
Freemill Functionality ?
-
- Posts: 2405
- Joined: Wed Aug 01, 2007 4:15 pm
- Location: Irvine, CA, USA
- Contact:
Freemill Functionality ?
Make sure the Wizard Bar under the View menu item is checked.
This will bring up a dockable dialog bar on the side where you can enter parameters to program parts.
This will bring up a dockable dialog bar on the side where you can enter parameters to program parts.