HI,
My MCU trail is over and I need this tool.
How can I register this powerfull tool for free usage?
Please give some instruktions here.
Thanks
Peter
How to get the MCU Light lizens
-
MecSoft Support
- Posts: 2405
- Joined: Wed Aug 01, 2007 4:15 pm
- Location: Irvine, CA, USA
- Contact:
-
MecSoft Support
- Posts: 2405
- Joined: Wed Aug 01, 2007 4:15 pm
- Location: Irvine, CA, USA
- Contact:
How to get the MCU Light lizens
This was a reply from Bill at MetaCut
MCU Light will continue to run, but it must be started from within VisualMill. If you wish to run MCU Light or the full version of MCU as a stand-alone application, or on another computer, you will need to purchase it. (Light: $99, Level 1:$600) Light has most of the features of Level 1, with the notable exceptions of Solid verification, Edit revision control, and graphical compare. You can find a complete description of the differences at the MetaCut website here: http://www.metacut.com/Products/MCUFeatureList.htm
MCU Light will continue to run, but it must be started from within VisualMill. If you wish to run MCU Light or the full version of MCU as a stand-alone application, or on another computer, you will need to purchase it. (Light: $99, Level 1:$600) Light has most of the features of Level 1, with the notable exceptions of Solid verification, Edit revision control, and graphical compare. You can find a complete description of the differences at the MetaCut website here: http://www.metacut.com/Products/MCUFeatureList.htm