I've found you cannot change the input fields on the Entry/Exit Tab on all the 2 1/2 axis MOPs I've tried. For example with facing, if you change the angle from 20 degrees to 10 degrees click save then reopen the parameters it will reset to 20 degrees. There is a work around, if you enter the number you want then click the spinner up then down back to the number you entered it will save correctly.
Mark.
2 1/2 Axis Entry/Exit Bug.
-
MecSoft Support
- Posts: 2405
- Joined: Wed Aug 01, 2007 4:15 pm
- Location: Irvine, CA, USA
- Contact:
-
MecSoft Support
- Posts: 2405
- Joined: Wed Aug 01, 2007 4:15 pm
- Location: Irvine, CA, USA
- Contact:
2 1/2 Axis Entry/Exit Bug.
THis is a bug and we will fix it. The UI is not updating the values.