Another Regions Question

bludin · Post by **bludin** » Sat Dec 27, 2003 9:29 am

Hi all,

Has anyone figured out how to use a combination of the C-Plane (i.e. the grid plane) and the automated Curve/Region tools such as "All Flat Area Regions" or "Extract Edge Curves" to create a region (or regions) just on the selected C Plane? These new VM5 tools are terrific for creating complex regions from a part's geometry, but they also create lots of (potentially) unecessary regions.

If there is a way to use these tools just on the C-Plane - that would give a lot more control and flexibility.

Cheers, Peter

GreggT · Post by **GreggT** » Wed Mar 03, 2004 4:19 pm

That would be great.

Project to CPlane would be great too.

GreggT

bludin · Post by **bludin** » Thu Mar 04, 2004 7:14 am

Yes that would be handy. For the time being, I just use "All Flat Area Regions" to create regions in an empty layer, then switch to side view and rectangle select and delete all regions that are not in the CPlane. Works well enough for my stuff. Of course, If you have tru 3-D parts a projection tool would be much more powerful (in addition to all the mouse-clicks you could save).

Beat

Post by **MecSoft Support** » Thu Mar 04, 2004 4:47 pm

This is already in our list of things to do for the next release. Keep it coming guys!