Hi i'm looking for advise on cutting a keyway on a shaft, i want to do a 3/16" keyway with a 3/16" cutter so just do a full width slot.
i also don't have any smaller end mills for pocketing is out of the question right now.
the only way i can figure it out at the moment is use the engrave option to cut on the line.
Thank you for any help
Ian Dunlop
Cutting keyway
-
- Posts: 3
- Joined: Mon May 19, 2014 1:04 pm
Cutting keyway
- Attachments
-
- keyway.JPG (46.57 KiB) Viewed 10090 times
Re: Cutting keyway
SLOTTING, under the 2 1/2 Axis tab should enable you to do this:-
- Attachments
-
- Screenshot 2021-11-13 150459.jpg (247 KiB) Viewed 10052 times
-
- Posts: 3
- Joined: Mon May 19, 2014 1:04 pm
Re: Cutting keyway
Thanks for the reply sorry for the delay
Ian
Ian