I tried calling in but wonder if power or fires are effecting you guys.
When I set my feed rate reduction to 70%, it cuts the first part at the designated z-level with a feed rate of 70% as requested, but when it goes to cut the second part (I am using "level first") the feed rate jumps to 100% and stays there.
I hope the next version will solve this. Or if I am doing something wrong, please let me know.
Thanks
Feed rate reduction observation
-
- Posts: 9
- Joined: Fri Mar 29, 2019 8:12 am
Feed rate reduction observation
-Clint Chase
Chase Small Craft
Chase Small Craft
-
- Posts: 2405
- Joined: Wed Aug 01, 2007 4:15 pm
- Location: Irvine, CA, USA
- Contact:
Re: Feed rate reduction observation
Our phone lines are working as we have been receiving calls.
Yes, this has been fixed for version 2020 release.When I set my feed rate reduction to 70%, it cuts the first part at the designated z-level with a feed rate of 70% as requested, but when it goes to cut the second part (I am using "level first") the feed rate jumps to 100% and stays there.
I hope the next version will solve this. Or if I am doing something wrong, please let me know.