About Visual Mill About Visual Mill About Visual Mill About

All discussion related to VisualCAM for SolidWorks
Locked
gumbyrulesyou
Posts: 34
Joined: Fri Jan 22, 2010 10:08 am

About Visual Mill About Visual Mill About Visual Mill About

Post by gumbyrulesyou »

After upgrading from 2011 - Probably not an issue, but amusing none the less.
Attachments
Off to a good start.JPG
Off to a good start.JPG (22.3 KiB) Viewed 17078 times
Andy Baker
Brooklyn, NY
Andy Birko
Posts: 13
Joined: Sun Feb 13, 2011 12:51 pm
Contact:

Re: About Visual Mill About Visual Mill About Visual Mill Ab

Post by Andy Birko »

I second that.
mqbeers
Posts: 2
Joined: Sat Aug 07, 2010 6:03 am

Re: About Visual Mill About Visual Mill About Visual Mill Ab

Post by mqbeers »

Same issue for me. What happened to the usual selections in the menu tab?
MecSoft Support
Posts: 2405
Joined: Wed Aug 01, 2007 4:15 pm
Location: Irvine, CA, USA
Contact:

Re: About Visual Mill About Visual Mill About Visual Mill Ab

Post by MecSoft Support »

It looks like the VisualMILL 6.0 for SolidWorks did not uninstall properly. You might have been using VisualMILL 6 on SolidWorks 2012 and the older installer did not account for the 2012 product. You can run this exe to clean out the registry. Please follow this procedure:

1) Uninstall VisualMILL 2012 for SolidWorks
2) Run the RemCmdTab.exe (use the 32 or 64 bit versions as appropriate)
RemCmdTab64.rar
(12.42 KiB) Downloaded 1470 times
RemCmdTab32.rar
(9.02 KiB) Downloaded 1472 times
3) Reinstall VisualMILL 2012 for SolidWorks

This should fix the problem.
mqbeers
Posts: 2
Joined: Sat Aug 07, 2010 6:03 am

Re: About Visual Mill About Visual Mill About Visual Mill Ab

Post by mqbeers »

Thank you for your timely response. Following the steps in the last post did solve the problem and the interface is now showing correctly.
Locked