Feed rate reduction observation

All topics related to RhinoCAM
Post Reply
MS1553872302
Posts: 9
Joined: Fri Mar 29, 2019 8:12 am

Feed rate reduction observation

Post by MS1553872302 »

I tried calling in but wonder if power or fires are effecting you guys.

When I set my feed rate reduction to 70%, it cuts the first part at the designated z-level with a feed rate of 70% as requested, but when it goes to cut the second part (I am using "level first") the feed rate jumps to 100% and stays there.

I hope the next version will solve this. Or if I am doing something wrong, please let me know.

Thanks
-Clint Chase
Chase Small Craft
MecSoft Support
Posts: 2405
Joined: Wed Aug 01, 2007 4:15 pm
Location: Irvine, CA, USA
Contact:

Re: Feed rate reduction observation

Post by MecSoft Support »

Our phone lines are working as we have been receiving calls.
When I set my feed rate reduction to 70%, it cuts the first part at the designated z-level with a feed rate of 70% as requested, but when it goes to cut the second part (I am using "level first") the feed rate jumps to 100% and stays there.
I hope the next version will solve this. Or if I am doing something wrong, please let me know.
Yes, this has been fixed for version 2020 release.
Post Reply