Drag Knife Path

All topics related to RhinoCAM

Drag Knife Path

Postby MS1603318257 » Fri Mar 26, 2021 1:17 pm

Hi,
I am trying to create a dragknife path. It does not run it as a steady path but adds swivel actions to each curve. I have alot of curves and what should take a short time is taking way too long.
Is the swivel action method the only way of programming the drag knives?
MS1603318257
 
Posts: 6
Joined: Wed Oct 21, 2020 3:12 pm

Re: Drag Knife Path

Postby MecSoft Support » Thu Apr 01, 2021 10:12 am

Yes, Knife cutting operation would apply swivel actions for Drag knife swivel type. You can set the corner angle limit to control the corner swivel control under cut parameters tab. If you do not want swivel actions in your toolpath, you can try using 2 axis engraving.
MecSoft Support
 
Posts: 2524
Joined: Wed Aug 01, 2007 4:15 pm
Location: Irvine, CA, USA


Return to RhinoCAM Topics & Support

Who is online

Users browsing this forum: No registered users and 2 guests