Rhino 4 files support in VM5

luthimate · Post by **luthimate** » Mon Mar 19, 2007 4:00 am

Hi,

I'm a Rhino and VM user.
I just upgraded Rhino from v3 to v4
But to use Rhino file in VM , I have to save in Rhino v3 file format.
I'm sure you have planed to provide a Service Pack for VM5 to open Rhino v4 files.
Can you give a clue when this patch will be available?

Thanks,

Damien , LUTHIMATE

Post by **MecSoft Support** » Mon Mar 19, 2007 10:23 am

Hi Damien,

Rhino 4.0 is a Unicode application which means that applications that read Rhino 4.0 files need also to be unicode applications. Since VisualMill 5.0 is not a unicode application we will be unable to read Rhino 4.0 files. However, our development department is looking at this issue and will have a determination on this in the next few weeks.

luthimate · Post by **luthimate** » Mon Mar 19, 2007 1:56 pm

thank you for answer.
So I wait to see the decision of development department.