Multi Z Profiling-I can only get the Radius Lead in on the first pass. A straight lead in is applied to each subsequent pass.
What am I missing?
Thank You
| Attachments: |
|
| MecSoft Corporation https://www.mecsoft.com/phpbb/ |
|
| Lead In-2-1/2 Axis https://www.mecsoft.com/phpbb/viewtopic.php?f=6&t=3572 |
Page 1 of 1 |
| Author: | 1449157671 [ Mon Oct 28, 2019 2:18 pm ] | ||
| Post subject: | Lead In-2-1/2 Axis | ||
Multi Z Profiling-I can only get the Radius Lead in on the first pass. A straight lead in is applied to each subsequent pass. What am I missing? Thank You
|
|||
| Author: | 1449157671 [ Fri Nov 01, 2019 10:15 am ] |
| Post subject: | Re: Lead In-2-1/2 Axis |
Seems like any answer would be better than no answer...... |
|
| Author: | MecSoft Support [ Fri Nov 01, 2019 11:06 am ] |
| Post subject: | Re: Lead In-2-1/2 Axis |
Thanks for the part file. We are reviewing it to determine a resolution for you. |
|
| Author: | MecSoft Support [ Fri Nov 01, 2019 11:18 am ] | ||
| Post subject: | Re: Lead In-2-1/2 Axis | ||
Hello 1449157671, Have a look at the attached revised part. The start point was causing the issue. What did I do: 1.) Merge the curves into one curve (Curve Modeling > Merge) 2.) Moved the start point of the curve to midpoint of the side nearest when you had the start point previously (Curve Modeling > Start Point) 3.) Edit the mop, using the new curve and regenerate.
|
|||
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
|
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/ |
|
