Split Hollow Milling

Show us what you have done!
Post Reply
Chris.Botha
Posts: 72
Joined: Thu Apr 08, 2010 1:22 am

Split Hollow Milling

Post by Chris.Botha »

i have been fielding lot of emails about "methods" or "strategies" when it comes to milling. I always answer similar to this.. If you had to make it by hand how would you go about it. most people would have about 10 different ways to do it. milling is the same. look at what you are making. how hard it will be to clean up. what material you are casting in etc. and develop a strategy based on your needs. no magic bullet strategy's im afraid ;)

I almost had this one grown but decided wall incline vs damn grower lines was worth the post casting cleanup :)

I was going to assemble in wax but decided i prefer to polish inside then seat solder in platinum after casting.
Image
Image
Image
Image
Image
Image
Image
Wine me, dine me, tram my mill for me!
Post Reply