For some reason i have never been able to make a user defined tool, i made the curves in rhino then imported them to the used define tool window and it says it works but it wont work, i dont know how to fix it and mecsoft support never got back to me about it so if you know anything about the process of making a user defined tool please help!!!
-Connor
Exquisite Designs
phone: 831.768.9020
fax: 831.768.9030
email: [email protected]
DEFINING A TOOL???
-
- Posts: 2405
- Joined: Wed Aug 01, 2007 4:15 pm
- Location: Irvine, CA, USA
- Contact:
DEFINING A TOOL???
Doesn't anybody use Search anymore? Please do a search in the forum for help on user defined tools. Here is some more helpful information:
-------------------------------------
Here are some videos to help you understand how to define user defined tools.
Also note that the User defined tools can only be used in 2-1/2 Axis profiling. For 3 axis methods only the standard tools ball, flat, corner radius and Taper tools can be used.
http://www.mecsoft.com/SupportDocuments ... edTool1.ht
ml
http://www.mecsoft.com/SupportDocuments ... efinedTool
1.html
-------------------------------------
Here are some videos to help you understand how to define user defined tools.
Also note that the User defined tools can only be used in 2-1/2 Axis profiling. For 3 axis methods only the standard tools ball, flat, corner radius and Taper tools can be used.
http://www.mecsoft.com/SupportDocuments ... edTool1.ht
ml
http://www.mecsoft.com/SupportDocuments ... efinedTool
1.html