Boring Cycle?
Posted: Mon Sep 08, 2014 11:50 am
Hi,
We just installed our seat of Rhino-Turn and we can't seem to figure out the boring cycle. I don't see any options for depth of cut or finish passes? The boring bar just plunges to depth on center and that's all it does?
I am trying to bore a simple 1" diameter X 1" deep counterbore. Here is a picture of the part:
I tried consulting the help file but it said nothing about depth of cut either???
We just installed our seat of Rhino-Turn and we can't seem to figure out the boring cycle. I don't see any options for depth of cut or finish passes? The boring bar just plunges to depth on center and that's all it does?
I am trying to bore a simple 1" diameter X 1" deep counterbore. Here is a picture of the part:
I tried consulting the help file but it said nothing about depth of cut either???