Page 1 of 1
Assign View Shortcut Keys
Posted: Tue Mar 25, 2014 4:53 pm
by joblo
Does anybody know if it possible to assign shortcut keys to the different views in VM2012.
I am sure I used to be able to give the front, back, left. right etc views shortcut keys, but I have not been able to do that for a while now.
I found it quite useful and hope that there is some way to set them still.
Re: Assign View Shortcut Keys
Posted: Thu Mar 27, 2014 11:47 am
by MecSoft Support
Shortcut key assignment for different views is not available in VM2012. This can be done in the 2014 version of VisualCADCAM.
Re: Assign View Shortcut Keys
Posted: Thu Mar 27, 2014 1:12 pm
by joblo
Why were these functions removed, because I am quite sure it used to have it?
Re: Assign View Shortcut Keys
Posted: Fri Mar 28, 2014 1:52 pm
by MecSoft Support
They were not removed as you say in 2012. They were not implemented at all due to the limitations in the windowing libraries that we used to use. We have enhanced this in the 2014 release as previously mentioned.
Re: Assign View Shortcut Keys
Posted: Fri Mar 28, 2014 2:16 pm
by joblo
Okay, I guess you would know a lot better than me. Mayby I was getting it mixed up with another program.