Hi guys,
I am trying to engrave brick hatch but it is calculated to slow. Is there any solution for speeding up.
Thanks.
slow engraving calculation problem
slow engraving calculation problem
- Attachments
-
- slow engrave.vcp
- brick engraving
- (1.38 MiB) Downloaded 1170 times
-
MecSoft Support
- Posts: 2405
- Joined: Wed Aug 01, 2007 4:15 pm
- Location: Irvine, CA, USA
- Contact:
Re: slow engraving calculation problem
The engraving operation shows 3221 geometries selected as machining regions and it took about 2 minutes to generate the toolpath in 64 bit version of VisualCADCAM 2014. This seems to be reasonable for this large data set.
Re: slow engraving calculation problem
Thank you for your response. Honestly I was expecting such answer because I tried playing with all options and did not get faster engraving calculation. Please add my proposal in your customer's wish list: Speed up engraving calculation if you can. Anyway, many thanks for your support.
Best regards.
Best regards.