Assign View Shortcut Keys

All discussion related to the VisualCAD/CAM standalone product.
Post Reply
joblo
Posts: 13
Joined: Sat Aug 08, 2009 7:37 pm
Location: New Zealand

Assign View Shortcut Keys

Post by joblo »

Does anybody know if it possible to assign shortcut keys to the different views in VM2012.
I am sure I used to be able to give the front, back, left. right etc views shortcut keys, but I have not been able to do that for a while now.
I found it quite useful and hope that there is some way to set them still.
MecSoft Support
Posts: 2405
Joined: Wed Aug 01, 2007 4:15 pm
Location: Irvine, CA, USA
Contact:

Re: Assign View Shortcut Keys

Post by MecSoft Support »

Shortcut key assignment for different views is not available in VM2012. This can be done in the 2014 version of VisualCADCAM.
Attachments
ShortcutKeyAssignment.JPG
ShortcutKeyAssignment.JPG (31.46 KiB) Viewed 10940 times
joblo
Posts: 13
Joined: Sat Aug 08, 2009 7:37 pm
Location: New Zealand

Re: Assign View Shortcut Keys

Post by joblo »

Why were these functions removed, because I am quite sure it used to have it?
MecSoft Support
Posts: 2405
Joined: Wed Aug 01, 2007 4:15 pm
Location: Irvine, CA, USA
Contact:

Re: Assign View Shortcut Keys

Post by MecSoft Support »

They were not removed as you say in 2012. They were not implemented at all due to the limitations in the windowing libraries that we used to use. We have enhanced this in the 2014 release as previously mentioned.
joblo
Posts: 13
Joined: Sat Aug 08, 2009 7:37 pm
Location: New Zealand

Re: Assign View Shortcut Keys

Post by joblo »

Okay, I guess you would know a lot better than me. Mayby I was getting it mixed up with another program.
Post Reply